Davis Instruments Vantage Vue Wireless Weather Station DAV-6250EU 데이터 시트

4

Install the Rain Collector Tipping Spoon 
Assembly 

1. Locate the tipping spoon assembly slot on the 

underside of the ISS Base. 

2. Insert the wider end of the tipping spoon assembly 

into the slot first, sliding it under the raised lip of the 
slot.

3. Fit the narrow end into the slot and tighten the 

thumbscrew securely.

The Vantage Vue ISS rain collector debris screen captures 
debris that may otherwise clog your rain collector.

1. Locate the small black plastic ISS debris screen in your 

hardware package.

The debris screen has four small tabs that hold it in place 
in the base of the rain collector.

2. Holding the ISS assembly with one hand, and holding the 

debris screen by the top, press it into the opening in the 
rain collector until the tabs snap into the opening. 

The Vantage Vue ISS SIM board stores energy from the solar panel for power at night. A 3-
volt lithium battery provides a backup power source. The battery compartment is located on 
the underside of the ISS base. The compartment cover is included in the hardware packet.

To install the ISS backup battery.

1. Insert the 3-volt lithium battery into 

the ISS battery compartment, being 
sure to match the “+” sign on the 
battery with the “+” sign embossed 
on the inside of the battery 
compartment.

2. Ensure that the battery is properly in 

place, install the battery compart-
ment cover, and tighten the thumb-
screw. 

To verify power, wait 30 seconds 
then push and release the white transmitter ID pushbutton next to the battery compartment. 
The green transmitter ID LED next to the battery compartment will illuminate when you 
press the pushbutton.

Note: 

Press the pushbutton once and release it. Do not press it multiple times or hold it down.

Tipping spoon 
assembly

Tipping spoon 
assembly slot

Transmitter ID

pushbutton

Transmitter ID

LED

Battery 

compartment 

Battery compartment 
cover