Davis Instruments Vantage Vue Wireless Weather Station DAV-6250EU 데이터 시트

5

When you release the pushbutton, the LED will blink once (indicating transmitter ID 1), 
then begin to flash every 2.5 seconds to show transmission of a data packet. This flashing 
will stop within a few minutes to conserve battery life.

Note: 

If you have not already set up and powered your Vantage Vue console, do so before continuing with the 
ISS installation. For best reception, the console and ISS should be at least 10 feet (3 meters) apart.

3. The console acquires the radio signal and populates data fields. This usually occurs quickly, 

but in some enviromental conditions it can take up to 10 minutes.

Your Vantage Vue console can be used to listen to a Vantage Pro2 ISS instead of a Vantage 
Vue ISS, and an optional anemometer transmitter kit. 

Note: 

If you are using only the Vantage Vue console and ISS, and there are no other Davis weather stations 
nearby, you can skip to “Verify Data from the ISS” on page 6. 

In order to communicate, the console and ISS 
must have the same transmitter ID. At the 
factory, both IDs are set to a default of num-
ber 1. To confirm the transmitter ID of your 
Vantage Vue ISS:

1. Push and release the transmitter ID 

pushbutton once. It will illuminate and go 
off when you release it. 

2. After a short pause, it will blink one or 

more (up to 8) times. Note the number of 
times the transmitter ID LED blinks, indi-
cating its transmitter ID.

Unless you have intentionally changed your transmitter ID, the LED should blink one time 
because the default transmitter ID for the ISS is “1.” If you have changed the ID, the LED 
should blink the number of times equal to the ID you have set (i.e., twice for an ID of ‘2,’ 
three times for an ID of ‘3,’ etc.).

After blinking the transmitter ID, the light will begin to flash every 2.5 seconds, indicating 
packet transmission.

Note: 

The transmitter on the ISS and receiver on the console will communicate with each other only when both 
are set to the same transmitter ID.

Note: 

If you hold the pushbutton too long and accidentally enter the “set new transmitter ID” mode when you did 
not want to, simply release the pushbutton and wait four seconds. As long as you do not press the push-
button again, the original transmitter ID will remain in effect.

Note: 

In most cases, it will not be necessary to change the transmitter ID. If it is necessary to change the trans-
mitter ID, you must use the same ID for the ISS and console. 

The Vantage Vue ISS transmits weather information to the Vantage Vue console using one of 
eight selectable transmitter IDs. The default transmitter ID for both the ISS and the Vantage 
Vue console is 1. Change the transmitter ID if another Davis Instruments wireless weather sta-
tion is operating nearby and already uses transmitter ID 1, or if you have an optional Ane-

Transmitter ID 
pushbutton

Transmitter ID

LED