Nxp Semiconductors OM11043 데이터 시트

LPC1769_68_67_66_65_64_63

All information provided in this document is subject to legal disclaimers.

© NXP Semiconductors N.V. 2014. All rights reserved.

 

LPC1769_68_67_66_65_64_63 v.9.5 20140624 Product data sheet

-

LPC1769_68_67_66_65_64 v.9.4

Modifications:

SSP timing diagram updated. SSP timing parameters t

v(Q)

, t

h(Q)

, t

DS

, and t

DH

 

added. See 

.

Parameter T

j(max)

 added in 

SSP maximum bit rate in master mode corrected to 33 Mbit/s.

LPC1769_68_67_66_65_64_63 v.9.4 20140404 Product data sheet

-

LPC1769_68_67_66_65_64 v.9.3

Modifications:

Added LPC1768UK.

Table 5 “Pin description”: Changed RX_MCLK and TX_MCLK type from INPUT 
to OUTPUT.

LPC1769_68_67_66_65_64_63 v.9.3 20140108 Product data sheet

-

LPC1769_68_67_66_65_64 v.9.2

Modifications:

Table 7 “Thermal resistance (±15 %)”: 

– Added TFBGA100.

– Added 

15 % to table title.

LPC1769_68_67_66_65_64_63 v.9.2 20131021 Product data sheet

-

LPC1769_68_67_66_65_64 v.9.1

Modifications:

Table 8 “Static characteristics”: 

– Added Table note 3 “VDDA and VREFP should be tied to VDD(3V3) if the 

ADC and DAC are not used.”

– Added Table note 4 “VDDA for DAC specs are from 2.7 V to 3.6 V.”

– V

DDA

/VREFP spec changed from 2.7 V to 2.5 V.

Table 19 “ADC characteristics (full resolution)”: 

– Added Table note 1 “VDDA and VREFP should be tied to VDD(3V3) if the 

ADC and DAC are not used.”

– V

DDA

 changed from 2.7 V to 2.5 V.

Table 20 “ADC characteristics (lower resolution)”: Added Table note 1 “VDDA 
and VREFP should be tied to VDD(3V3) if the ADC and DAC are not used.”

LPC1769_68_67_66_65_64_63 v.9.1 20130916 Product data sheet

-

LPC1769_68_67_66_65_64 v.9

Modifications:

Added Table 7 “Thermal resistance”.

Table 6 “Limiting values”: 

– Updated min/max values for V

DD(3V3)

 and V

DD(REG)(3V3)

. 

– Updated conditions for V

I

.

– Updated table notes.

Table 8 “Static characteristics”: Added Table note 15 “TCK/SWDCLK pin needs 
to be externally pulled LOW.”

Updated Section 15.1 “Suggested USB interface solutions”.

Added Section 5 “Marking”.

Changed title of Figure 31 from “USB interface on a self-powered device” to 
“USB interface with soft-connect”.