High End Systems Technobeam 사용자 설명서

다운로드
페이지 173
Technobeam
®
 User Manual
Creating a Scene
4-5
4.
Press <Enter>, then use the <Up> and <Down> arrow keys to select ON.
5.
Press <Enter>.  The lamp is now ON, although it might not be visible if 
the dim flags (also called shutter or light gate) are closed.
Opening the Shutter
1.
Press and keep pressing the <Menu> key until ADDR appears in the 
LED display.
2.
Use the <Up> or <Down> arrow keys to navigate to the PRST menu.
3.
Press <Enter>, then use the <Up> or <Down> arrow keys to select EDIT.
4.
Press <Enter>; the LED display shows  SCN1 option, indicating you are 
now creating scene number 1.  The procedure that follows does not 
cover every available construct because each fixture is slightly 
different.
5.
Press <Enter> to begin creating scene 1.
6.
If you can see light exiting the fixture, the shutter is already open; skip 
to the next section.
7.
Use the <Up> and <Down> arrow keys to navigate to the SHUT 
construct.
8.
Press <Enter>, then press the <Up> and <Down> arrow keys to select 
OPEN
.
9.
Press <Enter>; light should now be visible through the aperture.  If so, 
see the next section.
10. If no light is visible through the aperture, either the shutter is still 
closed or the lamp is not on.  First look through the aperture (at an 
angle, not directly
) and make sure the two black dim flags are open, as 
shown in Figure 4-1.  (The two dim flags act as both the dimming 
mechanism and as the shutter.)
Figure 4-1.  Making sure the shutter is open.
Aperture (dim flags are barely visible at edges when shutter is open)