High End Systems Technobeam 사용자 설명서
2-8
Mounting the Fixture
Technobeam
®
User Manual
Figure 2-6. Connecting fixtures to a controller. Make sure you terminate the
last fixture in the link.
last fixture in the link.
Mounting the Fixture
You will need:
- one 1/4” allen wrench
- clamps and safety cable as described in this
section
- clamps and safety cable as described in this
section
Your fixture is designed to be mounted in any orientation: you can
even hang it with its aperture pointing straight down or stand it on its
end handles. However you wish to mount the fixture, you must follow
the precautions and suggestions below:
even hang it with its aperture pointing straight down or stand it on its
end handles. However you wish to mount the fixture, you must follow
the precautions and suggestions below:
•
Verify the input voltage you are using matches the fixture’s voltage
selection switches (see the section titled “Setting the Fixture
Voltage” on page 1-10).
selection switches (see the section titled “Setting the Fixture
Voltage” on page 1-10).
•
Heed the warnings below to guard against personal injury and
damage to the fixture.
damage to the fixture.
WARNINGS
(1) This equipment for connection to a
branch circuit having a maximum overload
protection of 20 A.
branch circuit having a maximum overload
protection of 20 A.
(2) Class I Equipment - This fixture must be
earthed.
earthed.
Controller
Data Out
Data In
Data Out
Data In
Data Out
Data In
Data Out
Data In
Terminate the
l
l
t fi t