Mellerware 30100 75 - 550 W 사용자 설명서

tal surface away from direct sunlight and
sources of heat (stove, heater, radiator etc).

3. This table top water dispenser is not recom-

mended for outdoor use.

4. NB: The water dispenser is pre-cleaned at

the factory but the reservoir and water lines
must be flushed with fresh water before us
as follows:

• Keep the dispenser unplugged
• Fill the water tank with tap water full to ca-

pacity. Wait for 5 minutes until water settles.

• Proceed to drain the water from both faucets

until no more water is remaining.

• Proceed to make sure both drain caps and

faucets are closed.

• Place the water bottle on the water intake;

allow water to stand approximately
one minute.

• Open water faucets to ensure water flows

from both faucets.

• Plug the dispenser into the electrical outlet.
• Turn the cold and hot water switches ON

(at the rear).

• Now you are ready to use your Table Top Hot

and Cold Water dispenser.

Instructions for cleaning:
• Unplug the dispenser from the power outlet.
• The dispenser was disinfected before leav-

ing the factory. You can use a fit for human
consumption disinfector to clean
it after six months.

• It is advisable to take it in for service after 1

year in order to clean the heating pot. This
must be done by a qualified technician.

• Care is needed when cleaning the appli-

ance to ensure that water do not go into the
electric power parts.

• Wash the inside of the reservoir with warm

water and baking soda solution. The solution
should be about 2 tablespoons of baking
soda to a quarter of water.

• The drip tray and water faucets should be

cleaned with mild detergent and warm water.

PROBLEM

SOLUTION

Dispenser does not work properly or water
does not flow out.

• Check if the appliance is plugged in

and switched on.

• Check if there’s water in the bottle
• Clear away any blockages in the reservoir.
• Check if the circuit break and see if not

tripped or a blow fuse.

Water is not hot enough

• Check to see if hot water switch

is turned on.

• Too much hot water has been used in a

short period of time. Allow it a few minutes it
will heat up again.

Water is not cold enough

• Check to see if cold water switch

is turned on.

• Too much cold water has been used in a

short period of time. Allow it a few minutes it
will heat up again.

Vibrations

• Check to see that the water

dispenser is level.

Leakage

• Check to see that the bottle is properly fitted

or change bottle if damaged.

_IM.indd   3

1/28/2014   1:45:12 PM