Adaptec 39106 사용자 설명서

Using the Adaptec SCSI 
Card 39160 and SCSI 
Devices

This section provides useful information on using the Adaptec SCSI 
Card 39160 and your SCSI devices. For more information about a 
specific SCSI device, refer to the documentation for that device.

Do not connect SCSI devices to more than two of 

the three SCSI Channel A connectors at the same time.

■

If you connect a SCSI hard disk drive to the Adaptec SCSI Card 
39160 that was previously connected to a different SCSI card, 
you must low-level format the drive before you can use it. Back 
up the data on the drive before you move it! (See Using SCSI 
Disk Utilities on page 24 for information on using the SCSISelect 
format utility.)

A low-level format destroys all data on the 

drive. Be sure to back up the data before performing a 
low-level format.

■

Every SCSI hard disk drive must be physically low-level for-
matted, partitioned, and logically formatted before it can be 
used to store data. Most SCSI drives are pre-formatted at the 
factory. If your SCSI hard disk drive has not been pre-format-
ted at the factory, and if your computer is running under DOS, 
Windows

®

 3.x, or Windows 95/98, you can format the disk 

with the DOS 

Fdisk

 and 

Format

 commands. (See the DOS and 

Windows documentation for more information.) To format