Compaq NX7000 사용자 설명서
5–46
Maintenance and Service Guide
Removal and Replacement Procedures
4. Lift the right side of the system board approximately
1 inch 1. If necessary, flex the back edge of the base
enclosure out so that the parallel 2 and serial connectors 3
clear the base enclosure.
enclosure out so that the parallel 2 and serial connectors 3
clear the base enclosure.
5. Slide the system board to the right at an angle 4.
6. Remove the system board.
Removing the System Board
Reverse the above procedure to install the system board.
325388-002.book Page 46 Friday, October 24, 2003 9:21 AM