Whirlpool W10388776A-SP Manual Do Utilizador

q

  Check that all parts are now installed. If there is an extra  

 

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

 

or kinked.

q

  Check that dryer is level. See “Level Dryer”.

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to    

 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide”.

q

  For power supply cord installation, plug into a grounded  

 

outlet. For direct wire installation, turn on Power.

Steam models only:

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucet, and hoses.

q

  If you live in a hard water area, use of a water softener is    

 

recommended to control the buildup of scale through the    

 

water system in the dryer. Over time, the buildup of lime  

 

scale may clog different parts of the water system, which will  

 

reduce product performance. Excessive scale buildup may  

 

lead to the need for certain part replacement or repair.

All Models:

q

  Select a Time Dry heated cycle, and start dryer. Do not select  

 

Air Only Temperature setting.

      If dryer will not start, check the following:

• Controls are set in a running or “On” position.

• Start button has been pushed firmly.

• Dryer is plugged into an outlet and/or electrical

 

  supply.

• Household fuse is intact and tight, or circuit breaker  

 

  has not tripped.

• Dryer door is closed.

This dryer automatically runs an installation diagnostic routine  

at the start of its first cycle.

If you receive an L2 code, there may  be a problem with you 

home power supply keeping the dryer’s heater from turning on. 

See “Troubleshooting”.

If you receive an AF code, your dryer vent may be crushed or 

blocked. See “Troubleshooting”.

You may notice an odor when dryer is first heated. This 

odor is common when heating element is first used. The odor will 

go away. 

Move dryer to final location. Avoid crushing or kinking vent. 

After dryer is in place, remove cardboard from under dryer.

       Not Level 

            

lEVEl                    Not Level

Check levelness of dryer from side to side. Repeat from  

front to back. 

noTE: The dryer must be level for the moisture sensing system 

to operate correctly.

Place 

level here

Place 

level here

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. Once 

legs are level, make sure all four legs are snug against the floor.