Fujifilm 4900 Manual Do Utilizador

123

122

I can’t use the flash to
take pictures.

• The Mode switch and Mode dial has been

moved to another setting.

• The flash is set to Suppressed Flash

mode (The flash is closed).

• You pressed the shutter button while the

flash was charging.

• Set the Mode switch and Mode dial to the

correct setting.

• Pop the flash up. (The flash cannot be

mode in which the flash can be used.)

• Wait until charging is completed before

pressing the shutter button.

The flash will not charge.

• No compatible SmartMedia is loaded.

• The camera is set to Suppressed Flash

mode.

• The camera is set to Macro Photography.
• The battery is exhausted.

• Load a new SmartMedia, erase a frame,

or remove the write-protection.

• Set the flash to Auto, Red-Eye Reduction

or Forced Flash mode.

• Cancel Macro Photography.
• Load a new battery.

The playback image is
too dark even though I
used the flash.

• The subject is too far away.
• Your finger covering the flash.

• Move closer to the subject.
• Hold the camera correctly.

The image is blurred.

• The lens is dirty
• The lens is zoomed to telephoto in Macro

mode.

• Clean the lens.
• Cancel Macro mode.

I can’t format the
SmartMedia.

• The SmartMedia is write-protected.

• Remove the write-protection.

(Peel off the write-protect sticker.)

The ERASE ALL function
does not erase all the
frames.

• The frame is protected.

• Remove the frame protection.

No power.

• The battery is exhausted.
• The AC power adapter plug has come out

of the power outlet.

• Load a new fully charged battery.
• Plug the adapter back in.

Power cuts out during
operation.

• The battery is exhausted.

• Load a new fully charged battery.

Battery runs out quickly.

• You are using the camera in extremely

cold conditions.

• The terminals are soiled.

• The battery is flat.

• Put the battery in your pocket or another

warm place to heat it and then load it into
the camera just before you take a picture.

• Wipe the battery terminals with a clean,

dry cloth.

• Load a new fully charged battery.

No photograph is taken
when the shutter button
is pressed.

• No SmartMedia is loaded.
• The SmartMedia is fully recorded.

• The SmartMedia is write-protected.
• The SmartMedia is not formatted.
• The SmartMedia contact area is soiled.

• The SmartMedia is damaged.
• The Auto Power Save function has

switched the camera off.

• The battery is exhausted.

• Load a SmartMedia.
• Load a new SmartMedia or erase a

frame.

• Remove the write-protection.
• Format the SmartMedia.
• Wipe the SmartMedia contact area with a

clean dry cloth.

• Load a new SmartMedia.
• Switch the camera on.

• Load a new fully charged battery.

e If you think the camera is faulty, check the following once more