Ariston 41-116-37 Manual Do Utilizador

26

To connect a room thermostat, it is necessary to:

1. Open the control panel
2. Loosen the cable clamp using a screwdriver and insert the wires 

leading from the room thermostat

3. Connect the wires to the terminals as indicated in the fi gure 

below, removing the link

4. If a remote time clock is to be fi tted, using a volt free switching 

time clock connect the switching wires from the time clock 
following points 1 - 3 above 

5. If using an external time clock and room thermostat, these must 

be connected in series as shown in diagram C,

6. Ensure that they are well connected and not subject to stress 

when the control panel is closed

DO NOT CONNECT 240V TO ANY PERIPHERAL CONNECTIONS

Outdoor sensor connection
-  Introduce the outdoor sensor wires
-  Loosen the cable clamp using a screwdriver and insert the 

wires leading from the outdoor sensor one at a time.

-  Connect the wires to the terminals as indicated in the fi gure 

below;

-  Make sure that they are well connected and that they are not 

subject to stress when the control panel lid is opened or closed;

-  Close the fl ap again, then replace the control panel cover and 

the front casing.

-  Refer to page 39 for setting the parameters when using the 

outdoor sensor.

Connector SE on PCB

Outdoor Sensor

   Connector TA on PCB
(low voltage switching)

   Connector TA on PCB
(low voltage switching)

   Connector TA on PCB
(low voltage switching)

 The boiler can be connected to a central heating system that 
uses two zone valves to allow connection to an indirect storage 
cylinder.
There are two wiring diagrams shown, one for the connection to 
an Unvented Cylinder and one for connection to an open vented 
cylinder.
In both cases the boiler connection is shown as TA1.

When connecting the boiler to an external cylinder do not run 
240V cables and the cables for the TA1 together, use separate 
cables to prevent induced voltage on the low voltage switching 
circuit.