Tanaka TLE-550 Manual Do Utilizador

 

 

 
www.tanakapowerequipment.com                             7                                              custsvc@tanaka-ism.com 

a. Take off the fixing nut, cutter holder cap and holder washer from the blade shaft. 
b. Install the blade on the shaft and then replace the holder washer, cutter holder cap, spring washer and fixing 

nut in order.  
c. Insert the locking bar into the hole of the cutter holder and gear case by lining up each hole. (Fig. 14) 
d. Tighten the fixing nut securely. 
 

a. Install guard adjusting bolt with washer 8 and bent washer. (Fig. 15) 
 

 
1. FUEL 
For proper lubrication, this engine must operate on a mixture of gasoline and TANAKA brand 2-cycle engine oil.   TANAKA 

2-cycle oil has been formulated to insure maximum engine performance and, increased engine life. The gasoline must be 

mixed according to the instructions on the oil bottle. If TANAKA oil isn't available, mix 50 parts of regular gasoline to 1 

part of quality 2 cycle mix. 
CAUTION: Do not use gasoline containing alcohol or gasohol as this may remit in engine failures. 
 
2. STARTING 
WARNING: Keep hands and feet away from cutting blade while starting engine and during operation. 

a. When starting engine, move stop switch to "START" position. If engine is cold, move choke lever to "CHOKE" 

position. (Fig. 16 & 17) 
b.  With the safety lever (13) pressed (if so equipped), pull throttle trigger and push lock button(3), then slowly 

release the throttle trigger first, then the safety lever. This will lock the throttle in starting position. (Fig. 16B) 

 
 
 
 
 
 
 
 
 

c. Pull the recoil starter upwards briskly several times or until engine attempts to start. Pull down choke lever to "RUN" 

position and continue to pull until engine starts. (Fig. 18) 

d. Let engine idle for about 3 minutes for warm-up. 

burned.