Tanaka TLE-550 Manual Do Utilizador

 

 

 
www.tanakapowerequipment.com                             8                                              custsvc@tanaka-ism.com 

a. To stop engine, release throttle lever and allow 
engine to return to idle, then move stop switch to 

the "STOP" position. (Fig. 16)

 

3. FUEL FILTER 
a. Clean as necessary. After all fuel 

drained from tank, gently pry out fuel 

filter with minus driver and wash it 

thoroughly in gasoline. After washing 

push it into the same place as before. 

(Fig. 21) 
NOTE: If the filter is hard due to dust 

and dirt, replace it.

 

a.  Always hold unit firmly with both hands and keep your body well balanced.  
b.  Cutting depth is controlled by adjust lever on left handle, by changing lock plate position, nine steps of 

cutting depth can be obtained. (Fig. 19) 

 
 

 

a. Follow the opposite procedure for installation. Section III #5. 
b. Care must be taken when handling sharpened blades. 
 

a. Clean sub-cleaner sponge every day or every eight hours of operation. More frequent cleaning is recommended 

under very dusty conditions. Wash the sponge in liquid detergent and water. Squeeze it to remove dirt and press 

it in a dry rag until it is completely dry. Saturate the sponge in 2-cycle oil or the equivalent. Squeeze it to 

distribute oil completely and to remove any excess oil. Replace sponge and install cover. (Fig. 20) 
b. The main cleaner sponge (carb side) should be cleaned and apply oil in the same way as abovementioned after 

every 50 hours of operation. More frequent cleaning may be required if operating in extremely dusty conditions. 

(Fig. 20)