Datalogic Scanning I GD4100 Manual Do Utilizador

General Features

Gryphon™ I GD4100

This setting specifies the amount of time that the reader stays in scan ON state once the state is 
entered. The range for this setting is from 1 to 255 seconds in 1-second increments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 

= 020, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming 

Mode.

4. Scan the barcode: SELECT SCANNING ACTIVE TIME SETTING.

5. Scan the appropriate three digits from the keypad in 

Appendix E, Keypad

, that represent the 

duration which was determined in the steps above. You will hear a two-beep indication 
after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming 

Mode.

This completes the procedure. See Table

4

 for some examples of how to set this feature.

1 Second

90 Sec. (1.5 min.)

180 Sec. (3 min.)

255 Seconds (4.25 min.)

001

090

180

255

Appendix E, Keypad

‘0’, ‘0’ and ‘1’

‘0’, ‘9’ and ‘0’

‘1’, ‘8’ and ‘0’

‘2’, ‘5’ and ‘5’