Thermador T30BB Manual Do Utilizador

*

The packaging protects your appliance from damage 

during transit. All utilized materials are environmentally 

safe and recyclable Please help us by disposing the 

packaging in an environmentally friendly manner.
Please ask your dealer or inquire at your local authority 

about current means of disposal.

*

Old appliances are not worthless rubbish! Valuable raw 

materials can be reclaimed by recycling old appliances.

,

WARNING: 
Redundant appliances
1. Pull out the mains plug.
2. Cut off the power cord and discard with 

the mains plug.

3. Do not take out the trays and receptacles: 

children are therefore prevented from climbing 

in!

4. Do not allow children to play with 

the appliance once it has spent it´s useful life. 

Danger of suffocation!

Refrigerators contain refrigerant and gases in 

the insulation. Refrigerant and gases must be disposed 

of professionally. Ensure that tubing of the refrigerant 

circuit is not damaged prior to proper disposal. 

Have a technician install and connect the appliance 

according to the enclosed installation instructions.

,

WARNING: 
Do not install this appliance:

■

outdoors,

■

in an environment with dripping water,

■

in rooms where there is a risk of frost.

The appliances are heavy and must be secured during 

transportation and installation.
Because of the weight/dimensions of the appliance 

and to minimise the risk of injuries and damage 

to the appliance at least two persons are necessary 

to set-up the appliance securely.

A dry, well ventilated room is suitable as an installation 

location. The installation location should not be 

exposed to direct sunlight and not placed near a heat 

source, e.g. a cooker, radiator, etc. If installation next to 

a heat source is unavoidable, use a suitable insulating 

plate or observe the following minimum distances from 

the heat source:

■

to electric or gas cookers 1

1

/

4

” (3 cm).

■

to an oil or coal-fired cooker 11

13

/

16

” (30 cm).

The floor of the installation location must not give way; 

if required, reinforce floor. To ensure that the ice maker 

functions correctly, the appliance must be upright.

The refrigeration unit is ventilated only via 

the ventilation grille in the base. Never cover 

the ventilation grille or place anything in front of it. 

Otherwise the refrigeration unit must work harder, 

increasing the power consumption.

After installing the appliance, wait at least 1 hour until 

the appliance starts up. During transportation the oil in 

the compressor may have flowed into the refrigeration 

system.
Before switching on the appliance for the first time, 

clean the interior of the appliance (see chapter 

“Cleaning the appliance”).

,

CAUTION: 
Connect the appliance to a drinking water line.

The water may be connected only by a competent fitter 

according to the local regulations of the appropriate 

water supply company.
A cold water connection is necessary for operating 

the automatic ice maker. The water pressure must be 

between 25 and 120 p.s.i. (1,72 and 8,25 bar). The 

installation must correspond to the local plumbing 

regulations.
A separate shut-off valve should be installed in 

the cold-water inflow.
The shut-off valve should not be located behind 

the appliance. It is recommended that you mount 

the shut-off valve directly next to the appliance or at 

another place which is easily accessible.
When installing the water connection, pay attention to 

the permissible installation area for the water mains.
For connection to the drinking water mains use only 

water pipes which are suitable for drinking water. 

Observe national regulations and the connection 

conditions of the local water supply companies.