Lexmark C530 Guia Do Utilizador

The following factory default settings are restored:

All downloaded resources in the printer memory are deleted. This includes fonts, macros, and symbol sets.

All settings return to the factory default settings except Display Language in the Setup menu and custom
settings in the Parallel, Serial, Network, Infrared, LocalTalk, USB, and Fax menus.

Make sure the printer is on and Ready appears.

From the control panel, press 

.

Press 

 until 

 appears, and then press 

.

Press 

 until 

 appears, and then press 

.

Press 

 until 

 appears, and then press 

.

Using the numeric keypad, enter the number of minutes for the printer to wait before entering the Power Saver
mode. Available settings range from 2–240 minutes.

If the printer does not have a numeric keypad, press the left and right arrows to change the setting.

Press 

.

 appears, followed by Ready.

Note: Power Saver settings can also be adjusted by issuing a Printer Job Language (PJL) command. For more
information, see the Technical Reference available on the Lexmark Web site at www.lexmark.com/publications.

This functionality is only available when a printer hard disk is installed and working properly.

Warning: All files and resources on the printer hard disk will be deleted. Resources residing in the printer flash
memory or RAM will not be affected.

Make sure the printer is turned off.

From the control panel, press and hold 

 and 

 while turning the printer on.

Release both buttons when Performing Self Test appears.

The printer performs its power-on sequence, and then CONFIG MENU appears.

Press 

 until 

 appears, and then press 

.

Press 

 until 

 appears, and then press 

.

 appears.

Press 

 until 

 appears, and then press 

.

A progress bar appears.

Administrative support