KitchenAid KDRS483VSS Guia Da Instalação

Install Griddle

(on griddle models)

The griddle is factory installed.
1.  Place drip tray in the well at the front of the griddle. 

Slide tray toward the back until it stops.

2.  Clean griddle before using. Refer to the Use and Care Guide.

Electronic Ignition System

Install the burner base, making sure the igniter electrode is 

properly aligned with the base. Place burner caps on top of 

burner bases. If burner caps are not properly positioned, surface 

burners will not light.

Cooktop burners use electronic igniters in place of standing 

pilots. When the cooktop control knob is turned to any position, 

the system creates a spark to light the burner. This sparking 

continues until the flame is lit or the knob is turned to OFF.
NOTE: The first time igniting the burners will take longer. This 

allows the gas to reach the burners during the first use.

Push in and turn each control knob to LITE.
NOTE: You will hear a clicking sound while the line clears.
The surface burners and grill flames should light within 

4 seconds. The first time a burner is lit, it may take longer 

than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control 

knobs to OFF.
If burners do not light properly:

 

■

Turn cooktop control knob to OFF.

 

■

Check that the range is plugged in and the circuit breaker 

has not tripped or the fuse has not blown.

 

■

Check that the gas shut-off valves are set to the 

“open” position.

 

■

Check that burner caps are properly positioned on 

burner bases.

Repeat startup. If a burner does not light at this point, contact 

your dealer or authorized service company for assistance.

The cooktop flame should be a steady blue flame approximately 

1

/

4

" (0.64 cm) high.

To Adjust Flame Height:
1.  Unplug range or disconnect power.
2.  Remove burner grates.
3.  Remove the control knobs.