KitchenAid KDRS483VSS Guia Da Instalação

4.  Open the oven door and remove the 2 screws on each side 

of the range that hold the control console in place.

NOTE: Make sure to leave oven door open or the control 

console will not rest in the side brackets properly once it 

is detached.

5.  Pull up on the control console, and let it drop forward into 

the notched console brackets on each side.

6.  Remove the round gasket from the valve stem.
7.  Put a control knob onto the valve stem of the burner you 

want to adjust.

8.  Turn the control knob to LO and, using a butane extension 

lighter, light the burner.

9.  Remove the control knob.

10. Use a 

1

/

8

" x 4

1

/

4

" flat-blade screwdriver to adjust the flame 

height. Tighten screw to reduce flame height. Loosen screw 

to increase flame height.
NOTE: When you are converting to LP gas, the screw 

should be tightened down completely on the single output 

valves. The dual output valve should not be adjusted.

11. When finished adjusting the flame height, put a control 

knob back onto the valve stem and turn off the burner.

12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that 

need adjustment.

15. Lift up on the control console and set it back into place. 

For a proper fit, the flange of the control console must 

hook over the lip on the front of the range cooktop.

16. Check that the control console is flush with the top edge 

of the range.

17. Replace the 2 screws on each side of the control console.
18. Replace the control knobs.
19. Replace burner grates.
20. Test the flame by turning the control from LO to HI, checking 

the flame at each setting.