KitchenAid 15'' Automatic Ice Maker Guia Da Instalação

NOTE: If ice maker is not installed, please proceed to “Drain 
Pump Installation” section.
1. Push the selector switch to the Off position.

2. Unplug ice maker or disconnect power.
3. Turn off water supply. Wait 5 to 10 minutes for the ice to fall 

into the storage bin. Remove all ice from bin.

4. Unscrew the drain cap from the bottom of the water pan 

located inside the storage bin. Allow water to drain 
completely. Replace drain cap. See “Drain Cap” illustration.

5. If ice maker is built into cabinets, pull ice maker out of the 

opening.

6. Disconnect water supply line. See “Water Supply Line” 

illustration.

NOTE: Do not kink, smash or damage tubes or wires during 
installation.
1. Unplug ice maker or disconnect power.
2. Remove rear panel. See “Rear Panel” illustration for 5 screw 

locations. Pull rear panel away from the drain tube and 
discard.

3. Remove the old drain tube and clamp attached to the ice 

maker bin. 
NOTE: Discard old drain tube and clamp. 

4. Install new drain tube (

⁵⁄₈" I.D. x 5¹⁄₈") from ice maker bin to 

drain pump reservoir inlet using new adjustable clamps. See 
“Drain Tube” illustration.
NOTES:

■

Do not kink.

■

Trim tube length, if required.

5. Install vent tube (

⁵⁄₁₆" I.D. x 32" [81 cm]) to drain pump 

reservoir vent. Use one 

⁵⁄₈" small adjustable clamp, supplied. 

See “Parts Locations” illustration.
NOTE: Do not install household drain tube at this time.

¹⁄₄

¹⁄₄

A

B

C

D

E

A

C

B

⁷⁄₈

⁷⁄₈

A

A

 

A

B

C

D