KitchenAid 15'' Automatic Ice Maker Guia Da Instalação

6. Remove power cord clamp and ground screw attached to ice 

maker power cord, which is mounted to the unit base. See 
“Parts Locations” illustration. 
NOTE: Clamp and screw will be reused.

7. Slide drain pump into the ice maker base on the right side. 

The pump mounting tab should slip into the rectangular slot in 
the ice maker base. It will be necessary to tip the pump 
slightly to slip into the slot. See “Drain Pump Mounting Tab 
Slot” illustration.

8. Align the 2 screw holes at the rear of the pump. Use two #8-32 

x 

³⁄₈" screws, supplied. See “Parts Locations” illustration.

9. Connect drain tube to ice maker bin outlet (

⁵⁄₈" I.D.), using ⁷⁄₈" 

adjustable clamp, supplied. See “Drain Tube” illustration.

10. Coil ice maker power cord into a 4" (10.2 cm) diameter coil. 

Wrap electrical tape around the power cord in several places 
to keep the cord in a coil. Locate coiled power cord between 
the drain pump and side of enclosure and plug into the 
receptacle of the drain pump. See “Parts Locations” 
illustration.

11. Attach the drain pump power cord to ice maker unit base with 

clamp and screw (removed in Step 6) that was used to attach 
ice maker power cord. See “Parts Locations” illustration.

12. Place new rear panel (small one for 15" ice makers, large one 

for 18") against the back of the ice maker. Route the vent tube 
and drain pump discharge tube through cutouts in the rear 
panel.

13. Secure rear panel with original screws. See “Rear Panel” 

illustration.

14. Secure vent tube to back of ice maker using three clamps and 

three #8-32 x 

³⁄₈" screws, supplied. See “Vent Tube” 

illustration.

NOTE: Do not pinch, kink or damage the vent tube. Check that it 
is not damaged, or pinched or kinked between the cabinet and 
the ice maker.

⁵⁄₈

³⁄₈

A

B

C
D

E

F

G

A

A

A

B