Zanussi ZDT22001FA Manual Do Utilizador

1. While the appliance is in user mode, within about 5 seconds press programme button: the indicator

is on and the indicator

starts to flash.

2. Wait until the indicator goes off. The indicator

is off. The acoustic signal is off.

3. Press programme button to change the setting. The indicator

is on. The acoustic signal is on.

4. Press on/off button to confirm the setting.

BEFORE FIRST USE

1. Make sure that the current level of the

water softener agrees with the hardness

of the water supply. If not, adjust the level

of the water softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any processing

residuals that can still be inside the appliance.

Do not use detergent and do not load the

baskets.

When you start a programme, the appliance can

take up to 5 minutes to recharge the resin in the

water softener. It seems that the appliance is not

working. The washing phase starts only after this

procedure is completed. The procedure will be

repeated periodically.

ADDING SALT

Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after

you fill the salt container, start a programme.

ADDING RINSE AID

3 2 1

The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot

rinse phase.

DAILY USE

1. Open the water tap.

2. Press the on/off button to activate the

appliance.

Make sure that the appliance is in programme

selection mode.

• If the salt indicator is on, fill the salt

container.