Honeywell 50ZST Manual Do Utilizador

Audio Command Center Series Manual — P/N 51889:E1  6/8/2010

33

Field Programming

The following tables list the ACC-25/50 Series programmable features and the DIP switch settings 
required to select a parrticular feature.  A detailed description of each feature is presented in the fol-
lowing pages. 

Switch 8 shown 
in ON position

Switches 1 through 7 

shown in OFF position

EIA-485 Addressing Switches

ac

25

zswi

tch.wmf

ACC-FFT

SW1 shown in position when a 
Remote Microphone is installed

SW2 shown in position when 

a 2-wire connection is made 

to the telephone loop.

acc-fft

swi

tch.wmf

1

1

Enable Temporal Pattern Tone
(switches 2 & 3 must be OFF)

Disable Temporal Pattern Tone (factory default)
(tone generated as selected by switches 2 & 3)

This switch works in conjunction with switch 3 to determine tone to be generated over speakers

Tone transmitted before and after message transmission and as backup tone if message fails:
2 OFF, 3 OFF = Steady Tone
2 OFF, 3 ON -= Slow Whoop Tone (factory default)
2 ON, 3 OFF = Hi-Lo Tone
2 ON, 3 ON = Chime

Enable Tone Transmission Before Message
(factory default)

Disable Tone Transmission Before Message

Enable Tone Transmission After Message

Disable Tone Transmission After Message
(factory default)

6

This switch works in conjunction with switches 7 & 8 to determine number of times message will repeat 

7

This switch works in conjunction with switches 6 & 8 to determine number of times message will repeat

8

Number of times voice message will repeat:
6 OFF, 7 OFF, 8 OFF = Tone Only, No Voice
6 ON, 7 OFF, 8 OFF = 3
6 OFF, 7 ON, 8 OFF = 4
6 ON, 7 ON, 8 OFF = 6 (factory default)
6 OFF, 7 OFF, 8 ON = 8
6 ON, 7 ON, 8 ON = Infinite (until FACP NAC is reset)
All other settings for switches 6, 7 and 8 are invalid and will default to a message repeat of 3 times

1 Tone selection applies only to Message 1 (Fire Evac).  Message 2, Message 3, Message 4, and 

Message 5 will output only the message.