buell s1 lightning '97 Manual
7-35
TAIL LAMP
REMOVAL/DISASSEMBLY
Tail Lamp
1.
If necessary, remove tail lamp bulb (3).
a.
Remove two screws (1) to detach tail lamp lens.
b.
Turn bulb counterclockwise and remove.
2.
Remove two locknuts (7) (metric) and washers (6).
3.
Disconnect the three terminals and remove tail lamp.
Tail Lamp Bracket
1.
Remove seat and tail section. See
TAIL SECTION,
REMOVAL
in Section 2.
2.
Cut cable straps holding tail lamp wiring
harness to rear frame. Detach connector [P11] from main
wiring harness.
wiring harness.
3.
Remove seat wing screw (9).
4.
Remove bolt (4) to detach bracket from frame.
5.
Remove turn signals. See
6.
Remove tail lamp.
7.
Remove reflectors (8).
ASSEMBLY/INSTALLATION
Tail Lamp Bracket
1.
Install reflectors (8).
2.
Install tail lamp with washers (6) and locknuts (7) (metric).
3.
Install turn signals. See
4.
Attach bracket (5) to frame with bolt (4) and seat wing
screw (9).
screw (9).
5.
Use new cable straps to secure tail lamp wiring harness
to rear frame. Attach connector [P11] to main wiring har-
ness. See
to rear frame. Attach connector [P11] to main wiring har-
ness. See
6.
Install tail section and seat. See
TAIL SECTION, INSTAL-
LATION
in Section 2.
1
WARNING
Check for proper tail lamp and turn signal operation
before riding motorcycle. Visibility is a major concern for
motorcyclists. Failure to have proper lamp operation
could lead to personal injury.
before riding motorcycle. Visibility is a major concern for
motorcyclists. Failure to have proper lamp operation
could lead to personal injury.
7.
Check tail lamp and turn signals for proper operation.
8.
Use new cable straps to bundle the tail lamp wiring har-
ness under the tail section.
ness under the tail section.
Figure 7-35. Tail Lamp
b0234x7x
1.
Screw (2)
2.
Tail lamp
3.
Tail lamp bulb
4.
Bolt
5.
Tail lamp bracket
1
2
8
9
3
4
5
6
7
10
6.
Washer (2)
7.
Locknut (2) (metric)
8.
Reflector (2)
9.
Wing screw
10. Tail lamp connector [P11]