buell s1 lightning '97 Manual
2-55
TAIL SECTION
REMOVAL
1.
See
Loosen seat wing screw (1). Remove
seat by pulling up and back.
2.
Remove two screws (4) and nylon washers (3).
3.
Loosen fuel tank screw (6).
4.
Lift fuel tank (8) and withdraw tail section.
NOTE
See
FUEL TANK, REMOVAL
in Section 4 for information on
removing fuel tank from frame.
INSTALLATION
1.
Place tail section on frame so mounting holes align with
holes on frame.
holes on frame.
2.
See
Install two screws (4) and nylon wash-
ers (3).
NOTE
If fuel tank was removed, see
FUEL TANK, INSTALLATION
in
Section 4.
3.
Tighten screw (6) to 9-11 ft-lbs (12.2-14.9 Nm).
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
4.
Place seat on tail section. Tighten wing screw.
Figure 2-63. Tail Section
b0217x2x
1.
Seat wing screw
2.
Tail section
3.
Nylon washer (2)
4.
Torx screw (2)
5.
Seat
6.
Screw
7.
Washer
8.
Fuel tank
4
2
3
7
1
5
6
8