Fujitsu m3099ex-eh Manual Do Utilizador

M3099EX/EH OEM Manual

A-3

6   If you want to return to the ENDORSER INITIAL

screen (Screen 2), press [Mode 1] and [Mode 2] at a
time.

7   If you want to return to the initial status to read, press

[STOP].

You can choose whether to reset or not when HOPPER EMPTY is detected.

8   At Screen 1 press [Mode 1] nine times to go to the

ENDORSER RESET METHOD screen. (Screen 7)

9   Press [Mode 2] to see Screen 8. If “ON” is displayed,

the print number will be reset when HOPPER
EMPTY is detected. If “OFF” is displayed, it
wouldn’t. The “ON” or “OFF” status flips each time
you press [Mode 1]. The status will be set in
EEPROM automatically.

10 If you want to return to Screen 7, press [Mode 2].

If you want to close the job, go to  7 .

You can reset the print number to the initial number by operator panel as follows.

11 At Screen 1 press [Mode 1] ten times to go to the

ENDORSER RESET screen. (Screen 9)

12 Press [Mode 2] to see Screen 10. You may see current

print number. If you want to reset the number, press
[Mode 2]. And you can see Screen 11 for 3 sec. If you
don’t want it, press [Mode 1] to go to Screen 9.

If you want to close the job, go to  7 .

EEPROM Writing!!

Screen 6

<< SETUP MODE >>

ENDORSER  RESET METHOD

Screen 7

HOP-EMPTY RESET

ON

Screen 8

<< SETUP MODE >>

ENDORSER  RESET

Screen 9

RESET

VALUE    0 0 0 0 1

No-Mode 1

Yes-Mode 2

Screen 10

RESET Finish !!

         0 0 0 0 1

Screen 11