eutech-instruments cyberscan con 10 conductivitytds meter Manual Do Utilizador

22

Press the MI/

!

 key in the measurement (MEAS) mode, to input any data into the memory.

The meter will automatically store the displayed data into the memory.

Model

Parameters

CON 100

Conductivity & temperature

CON 200

Conductivity & temperature and/or TDS & temperature

A total of 16 sets of data can be stored into the memory of the meter. The memory stored is

identified by the memory number (in hexadecimal numbering format, i.e. from 0 to 9 followed

by A to F) as displayed at the bottom left corner of the screen. The Last-In-First-Out (LIFO)

method of memory management is used. See section 7.5 (Printing data from Memory) for

illustration.

If the memory is full, the first memory contents (i.e. memory #1) will be erased. Memory #2 is

reassigned #1 and so on, leaving the last space #F free to receive the latest input.

To store the value of the measurement into the

memory of the meter, press the MI/

!

 button. This

will store both the parameter (conductivity or TDS)

and the temperature into the memory. The MEM

annunciator will be displayed briefly to indicate that

the data has already been stored into memory. The

memory number indicator, at the bottom left hand

corner, will flash the number of memory stored.

Memory recall is invoked to recall the data sets

stored in memory. Memory recall is activated in the

following sequence: