MINOURA hypermag Manual Do Utilizador
- 2 -
!
!
!
!
!
!
!
!
!
!
WARNING
Use two-wheeled bicycles only. Tandems may be used if balanced correctly.
Remove all oils and moisture from the drive roller before use. Be sure the tire slippage just after
starting is not abnormal.
starting is not abnormal.
Keep both hands on handlebars at all times and maintain a normal riding position.
After you ride bicycle on the HyperMag trainer, remove all dirt and particles from the rear tire, so
that you'll have effective braking on your future rides.
that you'll have effective braking on your future rides.
Check the couplings supporting the rear hub for damage and cracks.
Accidents may occur from cracked or damaged couplings.
Accidents may occur from cracked or damaged couplings.
When using the HyperMag trainer, place it on a flat surface for safe training.
Adjust the rear wheel position properly to avoid any trouble such as tire burst that caused by the
tire touches the plastic case of the resistance unit.
tire touches the plastic case of the resistance unit.
Do not over-tighten the hub-clamp handles. Over-tightening may cause damage to the trainer or
bicycle frame. The clamp handles should be a snug and secure fit. Do not force!
bicycle frame. The clamp handles should be a snug and secure fit. Do not force!
Keep away from small children, hands and feet away from spinning rollers and wheels at all times.
Before use, make sure all bolts and nuts are securely fastened.
!
“ICE” system cannot be used on the HyperMag resistance unit.
!
If you will use HyperMag with an MTB, you should change your rear tire to a slick one from a knobby
one in order to prevent any problems caused by noise and vibration.
Also be sure there may be a problem that your tire will worn out easily if the roller pressure to the tire
is too weak or too strong. Keep correct pressure with adjusting the knob bolt.
one in order to prevent any problems caused by noise and vibration.
Also be sure there may be a problem that your tire will worn out easily if the roller pressure to the tire
is too weak or too strong. Keep correct pressure with adjusting the knob bolt.