MINOURA hypermag Manual Do Utilizador

- 3 -

1

Open the frame and the U-leg, and place on level floor.
If the rubber foot caps were twisted, adjust that each flat surfaces fully touch the floor.

2

Install the joint plate with the supplied M6 bolt and M6 nut.  At this time, be sure the welded nut on
the joint plate faces to the resistance unit side.
The joint plate must be free for rotating so you do NOT tighten the bolt firmly.

3

Insert the flat washer and the spring into the knob bolt, then tighten to the joint plate.  Make sure
the direction of the spring that the smaller diameter must face the plastic knob side.

4

The joint plate is designed to be foldable.
Grab the plate and rotate upward (see Fig.B).
When the plate becomes almost vertical, push down the plate and
insert its hook into the square hole on the frame bracket.
Lastly, pull the plate backward.
Now your next step is ready.

(Fig. B)

5

If you purchased the Type-R (remote control version), straighten
the remote shifter cable and put it through under the U-leg.  Be
sure do not bent the cable, especially at the bottom of it.

(Fig. A)