Autostart AS2402 Manual Do Utilizador

P. 4 

User Guide 

2.  The Parking Light will flash twice indicating the Module is now out of Valet Mode.  

The LED will turn 

. 

Valet Mode Using the Valet Button 
(Available only of the plug-in Valet switch is installed)  

To put the system into Valet Mode: 

1.  Turn the key to the 

 position. 

2.  Press (for at least 1 second) and release the Valet Button. The parking lights will 

flash 3 times and then turn the key to 

 position. The L.E.D. will come on. 

To take the system out of Valet Mode: 

1.  Turn the key to the 

 position. 

2.  Press (for at least 1 second) and release the Valet Button. The parking lights will 

flash twice and the L.E.D. will go 

. 

The Valet button can only be used if the vehicle keys are in the 

 position. 

Note:   Panic mode can only be activated if the horn has been adequately configured 

by your installer and if button 

Ι is programmed as 

 or 

 button. 

 

In an emergency situation, you can activate panic mode using the 

Ι

 button. This will: 

• shut down the engine, 
• unlock the doors (with the Ι button) 

• or lock the doors (with the Ι button), 

• disarm the Starter Kill and 

• activate the horn for 25 sec. 

 

Note: See the description of the starter kill option later in this Guide. 

•  Press and hold the 

Ι, 

button for approximately 3 sec. until the sound signal starts and 

the parking lights flash: this will unlock the doors before the sound signal starts. 

•  Or press and hold the 

Ι, 

button for approximately 3 seconds until the sound signal 

starts and the parking lights flash: this will lock the doors before the sound signal 

starts. 

Panic Mode will automatically shut down after 25 sec. 

Note: To stop panic mode before the end of its delay, press the 

Ι

 button until the sound 

signal stops. 

When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes 

(or for 20 minutes with Diesel engines); the routine goes on for a period of 24 hours. 

To enter Cold Weather Mode: 

•  Press and hold button ΙΙ until the parking lights flash 3 times. 
To exit Cold Weather Mode, do any one of the following: 

•  Open the hood. 

•  Start the engine using the remote control. 

•  Turn the ignition key to the

position. 

•  Press and hold button ΙΙ for 3 seconds 

(until the parking Lights flash once) 

•  Set the vehicle to Valet Mode. 

Advanced Features: Installation-programmable options 
The system was designed with flexibility and OEM integration in mind. With its programmable 

options, this unit can control nearly any electrical system in your vehicle.