TP-LINK TL-MR3420 Manual Do Utilizador

 

Choose menu “Advanced Routing  → System Routing Table”, you can configure the system 

routing table in the next screen (shown in Figure 4-63). System routing table views all of the 

valid route entries in use. 

 

Figure 4-63  System Routing Table 



 

Destination Network - The Destination Network is the address of the network or host to 

which the static route is assigned. 



 

Subnet Mask - The Subnet Mask determines which portion of an IP address is the network 

portion, and which portion is the host portion. 



 

Gateway - This is the IP address of the gateway device that allows for contact between the 

Router and the network or host. 



 

Interface - This interface tells you whether the Destination IP Address is on the LAN & 

WLAN (internal wired and wireless networks), the WAN (Internet). 

 

Figure 4-64 Bandwidth Control 

There are two submenus under the Bandwidth Control menu as shown in Figure 4-64. Click 

either of them, and you will be able to configure the corresponding function. The detailed 

explanations for each submenu are provided below. 

Choose menu “Bandwidth Control → Control Settings”, you can configure the Egress 

Bandwidth and Ingress Bandwidth in the next screen. Their values you configure should be less 

than 100000Kbps. For optimal control of the bandwidth, please select the right Line Type and 

ask your ISP for the total bandwidth of the egress and ingress.

 

-70-