Vocopro Cassette Deck Manual Do Utilizador

If your stereo system fails to operate, carefully read these instructions. 
Many problem situations are caused by improper use. Listed below are the most common ones.

Power switched on, but no sound 
and no light on the POWER LED.

The POWER LED system is on but 
no sound
Poor FM reception

System turned on and PLAY 
pressed, but no sound from TAPE.

Poor playback sound.

RECORD button cannot be pressed 
in.
Poor recording.

Tape speed is erratic.
Cannot copy from DECK 2 to 
DECK 1.

CD Player does not work properly.

NO song lyrics Appear on screen.

Poor AC power plug connection to 
wall outlet.

VOLUME control is at “0 "position.

Antenna not placed for best reception.

FUNCTION SELECTOR set 
improperly for tape playback.
PAUSE button pressed in.
Unrecorded tape inserted.
Dirty heads.

Cassette tape is badly stretched.
Heads have become magnetized.

Cassette without erase protection tabs 
is inserted.
Dirty heads.

Heads have become magnetized.

Microphone defective
Microphone cable broken or 
intermittent.
Dirty capstan and/or pressure roller.
Unrecorded tape inserted into 
DECK 2.
PLAY/RECORD function selector is in 
wrong position.
Disc is inserted upside down.
Disc is dirty.
Disc is scratched.
Disc seriously warped.
A nonstandard disc is inserted.
Moisture has formed inside the CD 
deck.
Video cable is not connected properly 
to the TV.

Source selector on TV is not set to 
VIDEO.
TV does not have video line input.

Connect AC correctly.
Old wall-outlets sometimes cause 
power loss Plug must fit snugly in 
outlet.
Adjust the VOLUME control to a 
proper sound level.
Move antenna wire around to obtain 
best reception.
Slide FUNCTION SELECTOR to 
TAPE.
Press and release the PAUSE button.
Insert recorded tape.
Clean heads. See TAPE DECK 
Cleaning.
Replace the cassette.
Degauss the play and record head 
with a tape head demagnetizer every 
100 hours of use.
Try another cassette, or place a piece 
of tape over the breakout tab holes.
Clean heads. See Tape Deck 
Cleaning.
Degauss the play and record head 
with a tape head demagnetizer every 
100 hours of use.
Replace microphone or microphone 
cord.

Clean the capstan and pressure roller.
Insert recorded tape.

Set to the proper position.

Insert disc correctly.
Wide clean with soft cloth.
Use a new disc.
Use a new disc.
Use only brand name disc.
Wait about 20 to 30 minutes to let it 
dry.
Connect the video cable to the 
Duet-II VIDEO OUT and to the TV 
VIDEO IN.
Using your TV Remote to select 
VIDEO or AUX input.
Connect from VIDEO OUT of the 
Duet-II to the AUX IN of your VCR of 
Connect to an RF Modulator and then 
to the TV cable input.