EMC DS-xxB2 Manual Do Utilizador

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

Installing the DS-xxB2 Rails

Square-Hole Channel

To install the rails assembly in the square-hole channel of the
rack/cabinet.

1. Align the holes of the front rail flange to the inside of the front

channel. The top and bottom screw holes are used for the screws
(see Figure 14 on page 16).

2. Secure the rail to a square-hole channel with two square-hole

washers and M5 x 16-mm flat-head screws (see Table 5 on
page 6). Leave the screws finger-tight, and tighten them after the
switch is installed.

3. Align the holes in the rear, U-shaped flange of the rail with the

holes in the rear inside channel, as shown in Figure 14.

4. Secure the rail to a square-hole channel with two square-hole

washers and M5 x 16-mm flat head screws (see Table 5 on page 6).
Leave the screws finger-tight, and tighten them after the switch is
installed.

5. Repeat steps 1 through 4 for the other rail.