EMC DS-xxB2 Manual Do Utilizador
EMC Departmental Switch DS-xxB2 Into Third-Party Racks
17
Installing the DS-xxB2 Switch
Installing the DS-xxB2 Switch
This section describes the procedures for installing the DS-xxB2
switch in a rack/cabinet, including attaching the brackets on the
switch.
switch in a rack/cabinet, including attaching the brackets on the
switch.
Mounting Bracket Installation
You must attach mounting brackets to the switch before installing it
on the rails. The mounting brackets slide into the “C” channel of the
rails.
on the rails. The mounting brackets slide into the “C” channel of the
rails.
To attach the mounting brackets to the switch:
1. Orient the L-shaped end of the bracket outward and to the power
outlet end of the switch.
2. Place the bracket against the switch. Align the three screw holes
in the bracket with three screw holes on the side of the switch (see
Figure 15 on page 17).
Figure 15 on page 17).
3. Secure the bracket with three 8-32 x 5/16-in. pan-head screws (see
Table 5 on page 6). Tighten the screws fully.
4. Repeat steps 1 through 3 for the other side of the switch to be
mounted.
Figure 15
Attaching the Switch Mounting Brackets
EMC2048
Switch
Mounting
Bracket
Mounting
Bracket
Switch
Mounting
Bracket
Mounting
Bracket
#8-32 x 5/16-in.
Pan Head Screw
(6)
Pan Head Screw
(6)
Hole