LG HW300G Manual Do Proprietário

12

ASSEMBLING AND PREPARING

 

y

Always provide proper ventilation for 
this projector.

- The projector is equipped with 

ventilation holes. Do not block or 
place anything near these holes. 
Internal heat build-up may occur, 
causing picture degradation or 
damage to the projector.

- Do not place the projector on 

a carpet, rug or other similar 
surface. It may prevent a adequate 
ventilation of the projector bottom. 
This product should be mounted to 
a wall or ceiling only.

- Never push the projector or spill 

any kind of liquid into the projector.

- Leave an adequate distance (30 

cm or more) around the projector.

 

y

Place this projector in adequate 
temperature and humidity 
conditions. 
-  Install this projector only in 

a location where adequate 
temperature and humidity is 
available. (See p.49)

 

y

Don’t place the projector where it 
can be covered with excessive dust. 
-  This may cause overheating of the 

projector.

 

y

Do not obstruct the slots and 
openings of the projector. This may 
cause overheating and cause a fire 
hazard.

 

y

This projector is manufactured using 
high-precision technology. You may, 
however, see tiny black points and/
or bright points (red, blue or green) 
that continuously appear on the 
projector Screen. This is a normal 
result of the manufacturing process 
and does not indicate a malfunction.

 

y

The remote control may not 
work when a lamp equipped 
with electronic ballast or a three-
wavelength lamp is installed. 
Replace those lamps with 
international standard products to 
use the remote control normally.