GE JGSP44 Manual Do Utilizador

The upper set of holes are intended for use with

an optional backsplash kit. If a backsplash kit is

being used, the stability bracket can be relocated

and put on the same time as the optional

backsplash kit. If the backsplash is not being

used, make sure that there are no countertop

structural supports which will interfere with the

stability bracket when located in the upper set of

holes.

Before placing range in the counter, check the

factory location of the stability device on the back

of the range. This location should work for most

installations. For convenience you can hook the

stability chain in the upper set of holes. Make

sure there is no structural interference when

using the upper set of holes.

1. Decide on a location that has no electrical wiring

or plumbing.

2. With the long screw provided anchor the chain to

the floor or wall.

3. Make sure the screw is going into the wall plate

or stud at the base of the wall at least 3/4".

4. Attach the stability chain so that it lines up with

the bracket on the back of the range.

5. Tug the chain to make sure it is securely fas-

tened.

6. Take the packaging tape and temporarily attach

the loose end of the chain to the rear of the

countertop.

7. Slide the range into the counter leaving enough

space behind to attach the chain to the bracket.

8. Slip the nearest link of the chain onto the bracket.

Pull to make sure it is as snug as possible.

9. Slide the range all the way back.  It is normal to

have some slack in the chain, but it should not

be excessive.