Справочник Пользователя для Hunter Fan 41597-01

Step 5-2: Ball Hanging Version

CAUTION: Do not lift motor by wires.

Insert pipe nipple through canopy and feed wires from top

of motor through pipe nipple. Screw pipe nipple into fan until

tight (at least 4-1/2 turns). The setscrew locking the pipe nipple

to motor must be tightened very securely. See Figure 5B. Failure

to tighten screw could result in fan falling.

Before hanging the fan from the ceiling plate align and

engage the (2) tabs in the bottom of the canopy with the (2)

grooves in the hanger ball. See Figure 5C.

Using the round hole in the top of the canopy, hang the fan from

the hook in the ceiling plate. Make sure both tabs in the canopy

remain engaged with the grooves in the ball. Be careful and don’t

scratch the finish while hanging the fan. See Figure 5A.

Step 6: Install Remote Control

and Final Wiring

CAUTION: This device complies with part 13 of the FCC rules.

Changes or modifications not expressly approved by Hunter Fan

Company could void your authority to operate this equipment.
Operation is Subject to the Following Two Conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operation.

NOTE: Use with a fan that incorporates an air gap switch (nor-

mal “ON-OFF” wall switch).
WARNING! Maximum fan load is 100 watts; maximum lamp is

240 watts. Do not use any speed control with this product.

Figure 5B

LEAD WIRES

PIPE

NIPPLE

BALL

PIPE NIPPLE

MOTOR

SETSCREW

(TIGHTEN

SECURELY)

CANOPY

Figure 5. Low Profile Version

Step 5-1: Fan Assembly

Low Profile Version

Place the canopy on top of the fan so the hole in the bottom

of the canopy fits over the adaptor on the top of the fan. See

Figure 5. Place the canopy assembly washer inside the canopy

with the vertical flange of the washer resting on the inside of

the canopy.

Position the (3) slots in the canopy assembly washer over

the (3) threaded holes in the adaptor. See Figure 5.

Secure the canopy to the top of the fan using the (3) #8-32

x 7/8 long screws with lock washers. Make certain all screws

ae tight. Failure to do so could result in the fan falling.
CAUTION: To ensure proper engagement of the canopy assem-

bly screws, the canopy must fit snug against the top of the fan.
CAUTION: Do not lift motor by wires.

Being careful not to scratch the canopy finish, hang the fan

from the hook in the ceiling plate using the round hole in the

top of the canopy. See Figures 5 and 5A.

ASSEMBLY

WASHER

#8-32 SCREW

CANOPY

ROUND HOLE

ADAPTOR

TOP OF FAN

Figure 5A. Hanging the Fan

FAN

CEILING PLATE

HOOK

CANOPY

Figure 5C. Aligning Tab & Groove

GROOVE IN

HANGER BALL

TAB IN BOTTOM

OF CANOPY

6” MIN.