Справочник Пользователя для Regency P33-LP4

Regency

®

 P33-4 Zero Clearance Direct Vent Gas Fireplace

34

6)  Open the bottom louver. Pull the Burner ON/OFF control box from 

inside the bottom of the fi replace and position the slots in the bracket 
over the 2 screws on the left side of the bottom louver. Push down 
to lock into place. Tighten the screws.

2)  Install the bay louver top heat shield and secure with 4 screws.

3)  Install top louver by sliding the two bracket clips into the brackets 

located on top of the bay door. See below. The fi tted louver leaves 
a small gap between faceplate bottom and louver top.

4)  Install bottom louver by sliding the two bracket clips into the brackets 

located underneath the bay door. Secure with 1 screw into each 
Bottom Louver Mounting Bracket as per diagram below. Use the 
bottom hole in the bracket.

5)  Slide the valve extension knobs onto the valve knobs. Match the 

correct ext. knob with the valve knob.

1)  Remove fl ush louver top heat shield by removing the 4 screws.