Справочник Пользователя для Regency P33-LP4

Regency

®

 P33-4 Zero Clearance Direct Vent Gas Fireplace

6

The P33-NG4 or P33-LP4 Direct Vent Fireplace 
must be installed in accordance with these 
instructions. Carefully read all the instructions 
in this manual fi rst. Consult the "authority 
having jurisdiction" to determine the need for 
a permit prior to starting the installation. It is 
the responsibility of the installer to ensure 
this fi replace is installed in compliance with 
manufacturer's instructions and all applicable 
codes.

Safe installation and operation of this appliance 
requires common sense, however, we are 
required by the Canadian Safety Standards 
and ANSI Standards to make you aware of 
the following:

1)  The appliance installation must conform with 

local codes or, in the absence of local codes, 

with the current  Canadian  or  National 

Gas Codes, CAN1-B149 or ANSI Z223.1 

Installation Codes.

2)  The appliance when installed, must be 

electrically grounded in accordance with 

local codes, or in the absence of local codes 

with the current National Electrical Code, 

ANSI/NFPA 70 or CSA C22.1 Canadian 

Electrical Code.

3)  See general construction and assembly 

instructions. The appliance and vent should 

be enclosed.

4)  This appliance must be connected to the 

specifi ed vent and termination cap to the 

outside of the building envelope. Never vent 

to another room or inside a building. Make 

sure that the vent is fi tted as per Venting 

instructions.

5)  Inspect the venting system annually for 

blockage and any signs of deterioration.   

6)  Venting terminals shall not be recessed into a 

wall or siding.

7)  Any safety glass removed for servicing 

must be replaced prior to operating the 

appliance.

8)  To prevent injury, do not allow anyone who 

is unfamiliar with the operation to use the 

fi replace.

9)  Wear gloves and safety glasses for protection 

while doing required maintenance.

10) Be aware of electrical wiring locations in 

walls and ceilings when cutting holes for 

termination.

11) Under no circumstances should this 

appliance be modifi ed. Parts that have to be 

removed for servicing should be replaced 

prior to operating this appliance.

12)  Installation and any repairs to this appliance 

should be done by a qualifi ed service 

person. A professional service person 

should be called to inspect this appliance 

annually. Make it a practice to have all of 

your gas appliances checked annually.

13) Do not slam shut or strike the glass door.

14) Under no circumstances should any solid 

fuels (wood, paper, cardboard, coal, etc.) 

be used in this appliance.

15) The appliance area must be kept clear and 

free of combustible materials, (gases and 

other fl ammable vapours and liquids).

1)  Ensure that structural members are not 

cut or weakened during installation.

2)  Ensure proper grounding using the #8 

ground lug provided. Refer to "Wiring 
Diagram" Section.

Emissions from burning  wood or gas could 
contain chemicals known to the State of 
California to  cause cancer, birth defects 
or other reproductive harm.