Справочник Пользователя для Integra DHC-9.9

43

■ If Your iPod Supports Video:

Connect your RI Dock’s audio output jacks to the 
AV controller’s AUX 1 IN L/R jacks, and connect its 
video output jack to the AV controller’s AUX 1 IN V 
jack.
(Onkyo DS-A2X hookup shown below.)

■ If Your iPod Doesn’t Support Video:

Connect your RI Dock’s audio output jacks to the 
AV controller’s AUX 1 IN L/R jacks.
(Onkyo DS-A2X hookup shown below.)

■ If you have an Onkyo DS-A1 RI Dock
• Connect its video output jack to the AV controller’s AUX 1 jack.

The AV controller has AC outlet on its rear panel that can be used to 
connect the power cords of other components that you intend to use 
with the AV controller. These components can then be left turned on 
so that they turn on and off as and when the AV controller is set to On 
or Standby.
Caution:
• Make sure that the total capacity of the components that you con-

nect to the AC OUTLET does not exceed the stated capacity.

Notes:
• When the “HDMI Control” setting is set to “Enable” (page 126), 

the AC outlet are on all the time regardless of whether the AV con-
troller is set to On or Standby, or Ready mode in this case, so any 
components connected to them cannot be turned on or off automat-
ically.

• Integra/Onkyo components connected via 

u should be connected 

directly to a wall outlet, not an AC OUTLET on the AV controller.

Notes:
• Connect the RI Dock to the AV controller with an 

u cable (see page 44).

• Set the RI Dock’s RI MODE switch to “HDD” or “HDD/DOCK”.
• Set the AV controller’s Input Display to “DOCK” (see page 57).
• By using the [Dock] Remote Mode button on the remote controller of the AV controller to change the remote 

mode to “DOCK”, you can operate your iPod in the RI Dock (see page 20).
If you cannot operate it, you will need to enter the appropriate remote control code (see page 137).

• See the RI Dock’s instruction manual for more information.