Справочник Пользователя для Integra DHC-9.9

44

With 

u (Remote Interactive), you can use the following special functions:

When you start playback on a component connected via 

u, if the AV controller is on Standby, it will automatically 

turn on and select that component as the input source. Similarly, when the AV controller is set to Standby, all compo-
nents connected via 

u will also go on Standby. This function will not work with components that are connected to an 

AC OUTLET on the AV controller.

When playback is started on a component connected via 

u, the AV controller automatically selects that component as 

the input source. If your DVD player is connected to the AV controller’s multichannel input, you’ll need to press the 
[Audio Sel] button repeatedly and select Multich to hear all channels (see page 129), as the Direct Change 

u function 

selects the DVD IN L/R jacks.

You can use the AV controller’s remote controller to control your other 

u-capable Integra/Onkyo components. You 

must enter the appropriate remote control code first (see page 138). And remember to point the remote controller at the 
AV controller and not the other component.

Notes:
• Use only 

u cables for u connections. u cables 

are supplied with Integra/Onkyo players (DVD, CD, 
etc.).

• Some components have two 

u jacks. You can con-

nect either one to the AV controller. The other jack is 
for connecting additional 

u-capable components.

• Connect only Integra/Onkyo components to 

u 

jacks. Connecting other manufacturer’s components 
may cause a malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Inte-
gra/Onkyo components.

• While Zone 2 or Zone 3 is on, the Auto Power 

On/Standby and Direct Change 

u functions do not 

work.

• Connect the power cord to the AV controller’s AC INLET.

• Plug the other end of the power cord into a suitable wall outlet.

• Turning on the AV controller may cause a momentary power surge that might interfere with other electrical equipment 

on the same circuit. If this is a problem, plug the AV controller into a different branch circuit.

u Components

Step 1: Make sure that each Integra/Onkyo component is connected to the AV controller with an analog audio cable 
(RCA).

Step 2: Make the necessary 

u connections (see illustration below).

Step 3: If you’re using an MD, CDR, or RI DOCK component, change the Input Display (see page 57).