Справочник Пользователя для Mitsubishi Electronics MR-J2S- CP
11 - 1
11. TROUBLESHOOTING
11. TROUBLESHOOTING
11.1 Trouble at start-up
CAUTION
Excessive adjustment or change of parameter setting must not be made as it will
make operation instable.
POINT
Using the MR Configurator (servo configuration software), you can refer to
unrotated servo motor reasons, etc.
unrotated servo motor reasons, etc.
The following faults may occur at start-up. If any of such faults occurs, take the corresponding action.
No.
Start-up sequence
Fault
Investigation
Possible cause
Reference
Not improved if connectors
CN1A, CN1B, CN2 and CN3
are disconnected.
CN1A, CN1B, CN2 and CN3
are disconnected.
1. Power supply voltage fault
2. Servo amplifier is faulty.
2. Servo amplifier is faulty.
Improved when connectors
CN1A and CN1B are
disconnected.
CN1A and CN1B are
disconnected.
Power supply of CN1 cabling is
shorted.
shorted.
Improved when connector
CN2 is disconnected.
CN2 is disconnected.
1. Power supply of encoder
cabling is shorted.
2. Encoder is faulty.
LED is not lit.
LED flickers.
LED flickers.
Improved when connector
CN3 is disconnected.
CN3 is disconnected.
Power supply of CN3 cabling is
shorted.
shorted.
1 Power
on
Alarm occurs.
Refer to section 11.2 and remove cause.
Section 11.2
Alarm occurs.
Refer to section 11.2 and remove cause.
Section 11.2
2 Switch
on
servo-on
signal.
Servo motor shaft is
not servo-locked
(is free).
not servo-locked
(is free).
1. Check the display to see if
the servo amplifier is
ready to operate.
ready to operate.
2. Check the external I/O
signal indication to see if
the servo-on (SON) signal
is ON.
the servo-on (SON) signal
is ON.
1. Servo-on signal is not input.
(Wiring mistake)
2. 24VDC power is not
supplied to COM.
Section 7.3.2
Rotation ripples
(speed fluctuations)
are large at low
speed.
(speed fluctuations)
are large at low
speed.
Make gain adjustment in the
following procedure.
1. Increase the auto tuning
following procedure.
1. Increase the auto tuning
response level.
2. Repeat acceleration and
deceleration several times
to complete auto tuning.
to complete auto tuning.
Gain adjustment fault
Chapter 7
3 Gain
adjustment
Large load inertia
moment causes the
servo motor shaft to
oscillate side to side.
moment causes the
servo motor shaft to
oscillate side to side.
If the servo motor may be
run with safety, repeat
acceleration and
deceleration several times to
complete auto tuning.
run with safety, repeat
acceleration and
deceleration several times to
complete auto tuning.
Gain adjustment fault
Chapter 7
4
Cyclic operation
Position shift occurs Confirm the cumulative
command pulses, cumulative
feedback pulses and actual
servo motor position.
feedback pulses and actual
servo motor position.
Pulse counting error, etc.
due to noise.
due to noise.