Справочник Пользователя для Enterasys Networks 3000
Component Description
1-4 Introduction
Security Slot
The access point includes a security slot on the rear panel. You can prevent unauthorized removal
of the access point by wrapping a Kensington security cable (not provided) around an unmovable
object, inserting the lock into the slot, and turning the key.
of the access point by wrapping a Kensington security cable (not provided) around an unmovable
object, inserting the lock into the slot, and turning the key.
Console Port
This port is used to connect a console device to the access point through a serial cable. This
connection is described in
connection is described in
. The console device can be a PC or workstation running a
VT‐100 terminal emulator, or a VT‐100 terminal.
Ethernet Port
The access point has one 10BASE‐T/100BASE‐TX RJ‐45 port that can be attached directly to
10BASE‐T/100BASE‐TX LAN segments. These segments must conform to the IEEE 802.3 or 802.3u
specifications.
10BASE‐T/100BASE‐TX LAN segments. These segments must conform to the IEEE 802.3 or 802.3u
specifications.
This port uses an MDI (for example, internal straight‐through) pin configuration. You can use a
straight‐through twisted‐pair cable to connect the port to most network interconnection devices,
such as a switch or router that provide MDI‐X ports. However, when connecting the access point
to a workstation or other device that do not have MDI‐X ports, you must use a crossover
twisted‐pair cable.
straight‐through twisted‐pair cable to connect the port to most network interconnection devices,
such as a switch or router that provide MDI‐X ports. However, when connecting the access point
to a workstation or other device that do not have MDI‐X ports, you must use a crossover
twisted‐pair cable.
The access point appears as an Ethernet node and performs a bridging function by moving
packets from the wired LAN to remote workstations on the wireless infrastructure.
packets from the wired LAN to remote workstations on the wireless infrastructure.
Reset Button
This button is used to reset the access point, or to restore the factory default configuration. If you
hold down the button for less than five seconds, the access point will perform a hardware reset. If
you hold down the button for five seconds or more, ALL configuration changes you made are
removed, and the factory default configuration is restored to the access point.
hold down the button for less than five seconds, the access point will perform a hardware reset. If
you hold down the button for five seconds or more, ALL configuration changes you made are
removed, and the factory default configuration is restored to the access point.
802.11g or 802.11b
Radio Interface 2
Radio Interface 2
On
Indicates a valid 802.11g or 802.11b wireless
link.
link.
Very Slow Flashing
Searching for network association.
Slow Flashing
Associated with network but no activity.
Fast Flashing
Indicates that the access point is transmitting or
receiving data through wireless links. Flashing
rate is proportional to network activity.
receiving data through wireless links. Flashing
rate is proportional to network activity.
Table 1-1 LED Indicator Descriptions (continued)
LED
Status
Description
B/G
Note: The RJ-45 port also supports Power over Ethernet (PoE) based on the IEEE 802.3af
standard. Refer to the description for the
standard. Refer to the description for the
on page 1-5 for information on
supplying power to the access point’s network port from a network device, such as a switch, that
provides Power over Ethernet (PoE).
provides Power over Ethernet (PoE).