Справочник Пользователя для Enterasys Networks 3000
RoamAbout Access Point 3000 Hardware Installation Guide C-1
C
Cables and Pin-outs
Twisted-Pair Cable Assignments
For 10/100BASE‐TX connections, a twisted‐pair cable must have two pairs of wires. Each wire pair
is identified by two different colors. For example, one wire might be green and the other, green
with white stripes. Also, an RJ‐45 connector must be attached to both ends of the cable.
is identified by two different colors. For example, one wire might be green and the other, green
with white stripes. Also, an RJ‐45 connector must be attached to both ends of the cable.
connectors in the same orientation when attaching the wires to the pins.
Figure C-1 RJ-45 Connector Pin-Out
Caution: DO NOT plug a phone jack connector into the RJ-45 port. Use only twisted-pair cables
with RJ-45 connectors that conform with FCC standards.
with RJ-45 connectors that conform with FCC standards.
Precaución: NO utilice un conector de teléfono en el puerto RJ-45. Utilice solamente cable de
par trenzado con conectores RJ-45 para cumplir con los estándares de la FCC.
par trenzado con conectores RJ-45 para cumplir con los estándares de la FCC.
Achtung: Verbinden Sie keine Telefonkabel mit dem RJ-45-Anschluss. Verwenden Sie
ausschließlich verdrillte Kabel mit RJ-45-Anschlüssen, die den FCC-Standards entsprechen.
ausschließlich verdrillte Kabel mit RJ-45-Anschlüssen, die den FCC-Standards entsprechen.
Caution: Each wire pair must be attached to the RJ-45 connectors in a specific orientation. (Refer
to “
to “
” on page C-3 for an explanation.)
Precaución: Cada par debe estar adjunto a los contactos del conector RJ-45 en una orientación
específica. Refiérase a “Straight-Through Wiring” y “Crossover Wiring” para una explicación al
respecto.
específica. Refiérase a “Straight-Through Wiring” y “Crossover Wiring” para una explicación al
respecto.
Achtung: Jedes Kabelpaar muss in einer bestimmten Ausrichtung mit den RJ-45-Anschlüssen
verbunden werden. Weitere Informationen hierzu finden Sie unter „Straight-Through Wiring“
(Standard-Verkabelung) und „Crossover Wiring“ (Crossover-Verkabelung).
verbunden werden. Weitere Informationen hierzu finden Sie unter „Straight-Through Wiring“
(Standard-Verkabelung) und „Crossover Wiring“ (Crossover-Verkabelung).
8
1
1
8