Справочник Пользователя для Pelco cm6800-322x6
44
C1522M-C (2/05)
PROGRAM CAMERAS
PELCO SWITCHER
MODEL CM6800
MAIN MENU
1
CAMERA
2
LOGICAL CAMERA
3
MONITOR
4
ACCESS
5
TIME & DATE
6
PORT
7
PRIORITY
8
SEQUENCE
9
MACRO
10
ALARM CONTACTS
11
EVENT TIMER
12
SET AUXILIARY
13
SET PASSWORD
14
ABOUT CM6800
ENGLISH
RETURN
00654
CAMERA 0001
VERTICAL DRIVE:
CONTROL:
PORT ADDRESS:
CONTROL:
PORT ADDRESS:
CAMERA TITLE
CAM 1
SELECT CHARACTER
RETURN
SELECT CHARACTER
RETURN
OFF
EXT COAX
01
EXT COAX
01
Figure 35. Program Cameras
1.
In the CAMERA field, select the logical camera number of the video input to be defined.
2.
In the CONTROL field, select the receiver control type.
EXT COAX: Coaxitron extended mode (32-bit)
STD COAX: Coaxitron standard mode (15-bit)
MUX: Genex multiplexer
PTZ-A: RS-422 Control Port A
M-02: Reserved for future use
M-08: Reserved for future use
STD COAX: Coaxitron standard mode (15-bit)
MUX: Genex multiplexer
PTZ-A: RS-422 Control Port A
M-02: Reserved for future use
M-08: Reserved for future use
NOTE: If you select PTZ-A you must also program Serial Port 6 (refer to Ports in this section).
3.
The PORT ADDRESS field is required for Genex or RS-422 control only.
Genex multiplexer: Select the address of the multiplexer (01-32); this address must match the unit ID specified through
multiplexer programming. Refer to the MX4000 Genex Series Simplex and Duplex Multiplexers Installation/Operation Manual.
multiplexer programming. Refer to the MX4000 Genex Series Simplex and Duplex Multiplexers Installation/Operation Manual.
RS-422 cameras: Select the camera/device address for RS-422 control (01-32). The port address must match the address setting
configured through the camera/receiver DIP switch settings.
configured through the camera/receiver DIP switch settings.