Руководство Пользователя для Quantum fc230
ATL P-Series Library User’s Guide Addendum - Prism FC230 Router
6331121-03, Ver. 3, Rel. 2
August 2002
CLI Command Types
9
If this is an initial installation, or a replacement FC230 board has
been installed, the HyperTerminal screen may not display
characters that are entered at the keyboard.
6
Enter the following commands to enable echo mode:
a
Type set serialportecho enabled, then press <Enter>.
b
Type saveconfiguration, then press <Enter>.
Wait for the
Ready
prompt before proceeding.
c
Type firmwarerestart, then press <Enter>.
The POST screen displays and the FC230 services software is ready
for use.
7
At the
Ready
prompt type
scsitargets 0
, then press
<Enter>.
S
cans bus 0 [of 2nd router board] and displays drives 8 and 9.
Figure 4 SCSI Bus Scan
Screen
Screen
CLI Command Types
0
Fibre Channel CLI commands have four types of operation:
• Immediate—causes an immediate action; not preceded by a get or
• Immediate—causes an immediate action; not preceded by a get or
set operation
• Get—returns the current value of a parameter (abbreviated “g”)
• Set—changes the value of a parameter (abbreviated “s”).
• Set—changes the value of a parameter (abbreviated “s”).
Note:
Firmware version 2.11 or higher automatically enables
echo mode.