Справочник Пользователя для Sony pdw-f335l

42

Preparing the Audio Input System

  Chap

te

r 2 

 Pr
epa

ra

tio
n

s

Open the CAC-12 and remove the microphone 
adaptor.

When attaching an ECM-673/674/678, use the 
microphone adaptor supplied with the ECM-673/674/
678.

Place an external microphone (electret condenser 
microphone such as the ECM-673/674/678) in the 
CAC-12.

Connect the microphone cable to the AUDIO IN CH-
1 or CH-2 connector. 

Set the switches as follows.

• Set the AUDIO IN input selection switch as 

indicated below, depending on the type of 
microphone used.
- When using a microphone with an internal 

power supply, set it to MIC (center).

- When using a microphone with an external 

power supply, set it to MIC +48V ON (right).

• Set the AUDIO IN (CH-1/CH-2/CH-3/CH-4) switch 

for the channel to which the microphone is 
connected to REAR (for CH-1/CH-2) or R (for CH-
3/CH-4).

Switch the input level to match the sensitivity of the 
microphone used.

Switch the input level by changing the REAR MIC 
REF setting on the AUDIO-1 page of the 
MAINTENANCE menu (factory default setting is –60 
dB). 

• If the input level on this unit is not at an appropriate 

setting for the microphone sensitivity, loud sounds may 
be distorted, and the signal-to-noise ratio may be 
affected.

• In order for the AUDIO IN CH-1 and CH-2 connectors 

on the camcorder to be able to provide a phantom 48 V 
power supply, female XLR connectors (3-pin) are fitted. 
If the microphone cable has a female connector, use an 
adaptor.

• When you detach a CAC-12 Microphone Holder once 

you have attached to the camcorder, be careful not to 
lose the two screws fixing the CAC-12 (in step 1). After 
detaching the CAC-12, be sure to put the two screws 
back into their original places.

You can record sound by using a wireless microphone 
system consisting of the following.
• WRT-804/807S UHF Wireless Microphone
• WRT-822/824 UHF Synthesized Transmitter
• WRR-855/861/862 UHF Synthesized Tuner

For the power source of this wireless microphone system, 
use Sony lithium-ion battery packs.

Microphone adaptor

Open the CAC-12.

Loosen the screw.

ECM-673/674/678 or 
similar microphone

Close the CAC-12.

Tighten the screw.

m

to AUDIO IN CH-1/CH-2 
connector

Monaural microphone

AUDIO IN (CH-1/CH-2) 
switches