Справочник Пользователя для Zanussi ZDT16030FA

duration of some programmes, water consumption

and the last rinse temperature can be affected.
The option XtraDry is not a permanent option and

must be selected at every cycle.

How to activate XtraDry
Press and hold simultaneously and until the
indicator

comes on.

If the option is not applicable to the program, the

related indicator does not come on or it flashes

quickly for a few seconds and then goes off.

The display shows the updated program duration.

BEFORE FIRST USE

1. Make sure that the current level of the

water softener agrees with the hardness

of the water supply. If not, adjust the level

of the water softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any processing

residuals that can still be inside the appliance.

Do not use detergent and do not load the

baskets.

When you start a programme, the appliance can

take up to 5 minutes to recharge the resin in the

water softener. It seems that the appliance is not

working. The washing phase starts only after this

procedure is completed. The procedure will be

repeated periodically.

ADDING SALT

Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after

you fill the salt container, start a programme.

ADDING RINSE AID

The rinse aid helps to dry dishes without streaks ans stains. It is automatically released during the hot rinse

phase.
• Fill the rinse aid dispenser until the rinse aid dispenser reaches the marking "MAX".

• Remove the spilled rinse aid with an absorbent cloth to prevent too much foam.

• Fill the rinse aid dispenser when the indicator (A) becomes clear.