Руководство По Установке для Panasonic SC-HT1500
3
3
Connect the speaker cables.
4
Adjust the speaker height.
≥Check the screws you tightened in procedures 1-3 and 2 -3 if the pipe and speaker are loose (
➡ page 2).
∫ Front and surround speaker height
(Assembled diagram)
5
Fasten the speaker cable.
≥Using the same polyfoam as done in procedure 2 will assist you in safely and securely fastening the speaker cables.
∫ For rear side of speaker
∫ For rear side of base
≥Twist off the vinyl ends of the speaker cable.
_: Copper
`: Silver
`: Silver
Push !
Rear side of speaker
1 Loosen the attached mounting plate screw
until the attached speaker is slightly loose
and adjustable.
and adjustable.
Be careful not to loosen the screw too much
or the speaker may detach and fall.
or the speaker may detach and fall.
2 With one hand on the base, and the other
holding the speaker, adjust the height of
the speaker up and down.
the speaker up and down.
Stopper screw
Screw to stop mounting plate from moving or sliding below
this point.
Screw to stop mounting plate from moving or sliding below
this point.
Phillips-head screwdriver
3 Tighten the mounting plate screw
securely.
Speaker
1122.5 mm
Pipe
Base
You can adjust within this
range.
range.
715.5 mm
Stopper screw
Do not remove.
Do not remove.
For your reference
You can enjoy good acoustics by
adjusting the height of the front and
surround speakers to the height of
the television so the center position
of both are approximately the same.
You can enjoy good acoustics by
adjusting the height of the front and
surround speakers to the height of
the television so the center position
of both are approximately the same.
Press the speaker cable
into the groove.
into the groove.
If there is any excess speaker
cable, thread the speaker
cable from the opening near
the top of the pipe while lightly
pulling the speaker cable from
the bottom of the base.
cable, thread the speaker
cable from the opening near
the top of the pipe while lightly
pulling the speaker cable from
the bottom of the base.
1 Press the speaker cable and thread
between the hooks.
2 Fit the speaker cable into the base cover groove
as far as possible.
Cable