Справочник Пользователя для AeroComm Corporation 4424200
Ordering Information
3/23/2006
28
5.2.9
Auto Config
The LT4424 has several variables that control its RF performance and vary by RF Mode and RF
Architecture. Enabling Auto Config will bypass the value for these variables stored in EEPROM and use
predetermined values for the given Interface Baud Rate. Auto Config has been optimized for 115200
baud Acknowledge Mode and all lower baud rates. It should only be disabled with recommendation
from Laird Technologies. Below is a list containing some of the variables affected by Auto Config and
their respective values:
Architecture. Enabling Auto Config will bypass the value for these variables stored in EEPROM and use
predetermined values for the given Interface Baud Rate. Auto Config has been optimized for 115200
baud Acknowledge Mode and all lower baud rates. It should only be disabled with recommendation
from Laird Technologies. Below is a list containing some of the variables affected by Auto Config and
their respective values:
Table 8 – Auto Config Parameters
Description
EEPROM
Address
Default
Acknowledge
Mode
47
5
5
48
60
60
4E
8
9
50
FD
FD
51
2
2
52
0
0
53
E4
E4
54
5
5
55
50
50
57
7
7
59
4
4
RF Packet Size
5B
40
40
CTS On
5C
C0
C0
CTS Hysteresis
5D
80
80
5E
0E
0E
5F
3
3
2
Parameters without a Description are undocumented protocol parameters and should only be modified to a
value other than shown in this table when recommended by Laird Technologies.