Инструкция для Whirlpool MEDB850YG

16

If you experience

Possible Causes

Solution

Dryer Results (cont.)

Load too hot

Load removed before cooldown 

portion of cycle complete.

Allow the dryer to complete the cooldown portion of the cycle before 

removing the load.

Using Timed Dry cycle with a high 

temperature setting.

Select a Sensor cycle with a lower heat setting to avoid overdrying the 

load.

Dryer Displaying Code Message or Indicator Is Lit

“PF” (power failure)

The drying cycle has been 

interrupted by a power failure.

Press and hold START to resume the cycle, or press POWER  

to select a new cycle

“L2” Diagnostic Code 

(low or no line voltage 

condition)

There may be a problem with your 

home power supply keeping the 

dryer’s heater from turning on.

The dryer will continue to run when this diagnostic code is present. Press 

any key to clear the code from the display and return to the estimated 

time remaining.

Try the following:
•  Check to see if a household fuse has blown or circuit breaker has 

tripped. Electric dryers use two household fuses or breakers. Replace 

the fuse or reset the circuit breaker.

•  Confirm the power cord is properly installed. Refer to Installation 

Instructions for details.

Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.

“F# E#” (F1 E1, F3 E1, 

etc.) variable service 

codes.

The dryer is in need of service.

If a code beginning with an “F” appears in the display. Alternating 

between F# and E#, the dryer control has detected a problem that 

requires service. Call for service.

Check Vent indicator 

is lit

The lint screen or vent is clogged; 

the vent is crushed, kinked or has 

too many turns.

The dryer will continue to run when this diagnostic code is present. Touch 

any key to clear the code from the display and return to the estimated 

time remaining.

Try the following:
• Clean lint screen.
•  Check to see if the vent run from the dryer to the wall is crushed  

or kinked.

•  Confirm that the vent run from the dryer to the wall is free of lint  

and debris.

•  Confirm that the exterior vent exhaust hood is free of lint and debris.
•  Confirm that your vent system falls within the recommended run length 

and number of elbows for the type of vent you are using. Refer to “Plan 

Vent System” in the Installaton Instructions for details.

 Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, have your entire home venting run cleaned. 

Contact a venting specialist.

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –  

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.